Zennie62 on YouTube

Friday, August 18, 2006

How To Get Raiders WR Randy Moss Open - Part One



I've been so critical of Oakland Raiders Offensive Coordinator Tom Walsh's approach , I figured it was only fair to place my own ideas out there.

Here's how I would solve the Raiders offensive line problem and get famed wide receiver Randy Moss open all at the same time.

Then formation here calls for a personal grouping of really three wide receivers and one back, but the third wide receiver plays flanker (Z) in the play, and Randy Moss is three-and-a-half-yards behind the weakside tackle where the fullback would normally be.

We place Moss in motion to the wide weakside before the snap of the ball. This forces the defense to 1) reveal its overall coverage and 2) place a slow defender -- more than likely a safety on first down -- on the fleet Moss. But this manuever also forces the defense to spread out to get Moss, thus leaving a nice passing lane for the tight end, who runs a five-yard out pattern. This second receiver in the pattern set will see the ball most of the time.

Note that Moss has an option to run either a fly pattern against man coverage or a kind of skinny post (break at 12 yards) into the seam of a three-deep defense, should the safety already be back in that position. It's not logical to try to run by the safety; we take our chances with the idea that we can drill our QB to make the throw on time to Moss should he chose to run the skinny post. We also chose the fly as the base pattern, in case the defense makes the mistake of not accouting for Moss in motion out of the backfield.

But Moss and the tight end open up the short middle for the halfback who runs a simple pattern to about 12 yards over the ball. There's nothing fancy here. The idea is to exploit the chance that between the free safety either covering the deep post or "spliting" the field and the middle linebackers moving into short hook zones or rushing the passer, that area will be open.

Finally, the Flanker runs a fake drive pattern, then turns and moves into what I call a "sweet spot" between the two deep zones post and corner and just over the hook zone. The Flanker's the fourth receiver.

The line blocking is zone-push: the linepeople don't give ground and instead push the defenders to keep them at bay. The strong guard is "uncovered" and so watches for the inside linebacker first and then the outside linebacker blitz. If the outside linebacker rushes, the guard slides out to get the defender. If both linebackers rush, the guard plays inside and the QB throws the hot pass to the halfback, who should be wide open.

The QB takes five steps-- three big and two small -- reading the weak safety and the middle linebackers as the drop back is taking place. Then once taking a hitch step set, looks to one, and if not open, then two, and so on...

In this case, the split end "Y" is a decoy that runs a pattern to basically shield the Flanker and then spread the defense wide and to the sideline, perhaps bring the free safety that way depending on the coverage. But a variation of this would have the split end as the primary receiver.

This can be the bread and butter play for any offense, but it's best use is to create a mismatch for Randy Moss. As for the o-line, we solve the problems they have faced by 1) QB and receiver timing and 2) an aggressive blocking style more like the run.

0 comments:

Visit the new Zennie62.com

Zennie62 blog net

 
Google Analytics Alternative